discharge gate

英 [dɪsˈtʃɑːdʒ ɡeɪt] 美 [dɪsˈtʃɑːrdʒ ɡeɪt]

网络  排出闸门; 卸料活门

化学



双语例句

  1. Experimental Research of Discharge Coefficient of the Plat Gate in Small Opening at High Water Head
    高水头闸室平板闸门小开度流量系数试验研究
  2. As soon as we opened the sluice, the water poured in. Study on Discharge Capacity of Water Gate in Tidal Plain Water Network Area
    我们一打开闸门,水就大量地涌了进来。平原感潮河网地区水闸泄流能力探讨
  3. Study on Discharge Capacity of Water Gate in Tidal Plain Water Network Area
    平原感潮河网地区水闸泄流能力探讨
  4. Research on Soft-sensing Technique for Water Discharge at Lateral Gate of the Irrigation Channel in the Yellow River
    引黄灌渠斗口水流量软测量技术研究
  5. Discharge the boxes at the gate, please.
    把箱子卸在大门口吧。
  6. Study on Discharge Coefficient for Steady Free Outflow under a High Dam Spillway Gate
    高坝平板闸门闸孔恒定自由出流流量系数研究
  7. The results demonstrate that the selection of filling discharge and pressure depends on the gate area, filling velocity and alloy type.
    半固态压铸机的充填流量及充填压力取决于浇口面积、充填速度以及合金种类。
  8. The main existing problem of discharge at the lateral gate of Hanyan canal in Ningxia is analyzed.
    分析了宁夏汉延渠斗口闸孔出流存在的主要问题。
  9. Experimental Studies on Reducing Discharge Capacity in Closed Conduit Due to Inflow in Gate Shaft
    闸门井进水减小泄水道泄流能力试验研究
  10. The experimental research of discharge calculation of vertical plane sluice gate
    直立平板闸门流量计算的实验研究
  11. The Discharge Rating of Free Flow in Arch Gate
    自由孔流弧型闸门流量率定
  12. In the case of small opening, submerged discharge, and water-stop rubber damage, the interaction between water and gate may cause vibration which result in gate damage.
    在小开度、淹没出流情况下,如果止水橡胶损坏,水和闸门的相互作用将导致闸门产生破坏性的振动。
  13. The discharge coefficient was affected by the angle of gate opening at the free discharge.
    试验结果表明,无论是在自由出流还是在淹没出流工况下,下卧式闸门开启角度对流量系数都有较大影响。
  14. Aggregate Discharge Coefficient of the Sluice Gate with Multi-opening, Wide Crest and Flat Bottom
    多孔宽顶平底泄洪闸综合流量系数的确定
  15. Hydraulic Correlative Discharge Theory of Automatic Turning Gate Controlled by Hydraulic Pressure
    水力自控翻板闸门泄流水力关联理论
  16. In this paper are suggested three design criteria of energy dissipation, i.e. rate of energy dissipation, ratio of max. discharge per unit width at downstream end of apron to that just at gate section and the vertical velocity distribution factor.
    本文建议供设计时采用的三个消能指标:消能率,闸门开启时护坦下游端的最大单宽流量与闸孔最大单宽流量之比,垂直流速分布系数。
  17. Fabrication of the discharge floating flap gate in Daxing Hydropower Station
    大兴电站排漂舌瓣门闸门制造
  18. Comparison of Design Methods for Support Beam of Lower Discharge Gate
    下出料门支撑梁设计方法的比较
  19. New technology and new construction, such as hydraulic coupling, dismountable scraper chain, pneumatic discharge gate valve and screw tensioning device with multi-spring buffer are used. The pneumatic discharge apparatus is one of the main energy consumption equipment in wood-working and wood-based panel industry.
    它采用液力偶合器、可拆式刮板链条、气动卸料闸门以及多弹簧缓冲的螺旋张紧装置等新技术、新结构。物料风送设备是木材加工和人造板生产中的主要耗能设备之一。
  20. To design a low-head control division project, the question deciding parameters will be met, such as: free flushing water levels, discharge per unit width of gates, net width of gates, elevation of gate sill, relative differences of heights of gates.
    在进行低水头引水枢纽设计时,必然会遇到决定如引水枢纽畅泄冲沙水位、各闸的单宽流量或闸室净宽、各闸底板高程、各闸之间的相对高差等参数问题。
  21. The principles and methods of calculating the discharge capacity of double sluice openings with a drop down flow in the gate shaft have been proposed and the formulas for calculating the discharges are listed with their corresponding coefficients given.
    文中提出了双层孔泄水和闸门井串水时泄水孔泄流能力的计算原则及方法,列出了流量的计算公式,并给出了一些经验系数值。
  22. Computation of Discharge under Sluice Gate with Horizontal Bottom
    平底闸平面闸门孔流流量计算
  23. By means of analogy of upper outline of the inlet to the free surface of corresponding jet issued under a gate, several formulae have been derived for calculating the main hydraulic parameters, e.g. discharge coefficient, friction coefficient, relative water depth in repair gate slot etc.
    同时还提出了估算其压板段阻力系数的计算公式,进而推导出计算检修闸门井内相对水深和检修闸门槽处水流空穴数等主要水力参数的计算方法。
  24. In analyzing the deformation and the strength of support beam of lower discharge gate, finite element method ( by using ANSYS) and engineering mechanics method ( strength of material) were used respectively. The results of two methods were, then, analyzed and compared.
    分析下出料门支撑梁的变形和强度对设备安全性能影响时,用有限元方法(ANSYS软件)和工程力学(材料力学)的方法分别进行计算、分析、比较。
  25. EXPERIMENTAL STUDY ON THE CAPACITY OF STORM INLETS Experiment research on discharge of gate in drain for rain water
    雨水口泄水量的试验研究雨水口篦子排水量试验探讨
  26. The discussion to some questions of discharge gate supervisory control system
    对溢洪闸门自动监控系统中几个问题的探讨
  27. Through dimension analysis, conclusions was drawn that the discharge coefficient of the gate was affected by the Reynolds number, the angle of gate opening, the relative length of the gate and the degree of submergence.
    通过因次分析,得出了下卧式闸门的流量系数主要受过闸水流的雷诺数、闸门开启角度、闸门相对长度以及过闸水流的相对淹没度的影响;
  28. In practice project, the form of the gate discharge structure in used by the main gate and radial gate flat.
    许多水电工程,泄水建筑物的闸门形式以平板闸门和弧形闸门两种形式为主。
  29. This paper studies used discharge tunnel sluice gate in the form of plates.
    本论文主要研究泄水隧洞的泄水闸采用平板闸门的形式。
  30. Pier of the large discharge structure is the critical structure to ensure that the arch gate could operate well under the high-thrust.
    大型泄水建筑物的闸墩是保证弧形工作闸门在大推力作用下安全运行的关键结构。